Case trimmer?

I watched a few vids on the FA and decided I didn't like their shellholder setup a whole lot. Seems to invite quite a few variables into setting it up. Sure it is functional and the FA is very reasonably priced, but I get the impression they are a bit of a combination of ford vs Chevy vs Yugo. It is built to a price point with some eye catching add-ons, and will get the job done, but leaves me with an uneasy feeling. But, all the bigger name companies have their share of eye catchers and perhaps dicy product as well.
 
Pretty much the same story for quality drills.
I tried some of our suppliers for CNC mills and they too have minimum too high.
Don't trust Amazon for quality drills. Tried that for #75, 79, 80 and .8mm micro drills for work and took over a month to get them.
HSS they all carry in stock, cheap. Then some say to get a complete set instead because they have that in stock.
I'll try a few others Like Drillmex, Tenaquip, Kar, Acklands-grainger when I get a chance.
 
Last edited:
Bought a Cobalt drill today, 19/64 HS CO GT-50 FYR Macedonia. $15,00
Did not even scratch a RCBS #10 shell holder using a drill press after 60 seconds.
Still sharp though.
Not spending the $65.00 for the Carbide drill they had,
 
You must log in or register to reply here.
Back
Top Bottom