So I haven't heard or seen much so I'm not sure what's in the works. I just wanted to ask about parts and IUR's. So I wanted to get another 3rd gen 15.7. Is Nordic ordering more uppers? If not I can buy the striped one. But where I can I find the others parts? I know parts are usually stripped from complete rifles. But I don't see CC heat shields, gas blocks, gas tubes, port doors and forwards assists anywhere. I know item inquiry threads can be nuisance sometime but I'm just curious. Thanks!
CC IUR's and Spare Parts?
- Thread starter Aiden26
- Start date
Aiden,
I dont know of anything in the works. We have had MRR's and complete Ambi + stripped lowers on order from Colt Canada since May. No ETA yet.
We have
15.7" SAS Barrels
third gen SAS IUR's (for the 15.7" barrels) these come with the nuts and required roll pins
IUR dust door kits
Forward assists, use the one from DPMS... they are identical.
Gas tube, use a normal carbine length one (a bent one works fine)
Gas bolck, any low profile .750 gas block will do the job.
We cannot source the forward assist, gas blocks, gas tubes or heat shields from Colt Canada. At least, not at this time.
The above will get you up and running. Hopefully at some point, Colt Canada will give us the straight tubes, heat shields and gas blocks to
make it 100%
Cheers
I dont know of anything in the works. We have had MRR's and complete Ambi + stripped lowers on order from Colt Canada since May. No ETA yet.
We have
15.7" SAS Barrels
third gen SAS IUR's (for the 15.7" barrels) these come with the nuts and required roll pins
IUR dust door kits
Forward assists, use the one from DPMS... they are identical.
Gas tube, use a normal carbine length one (a bent one works fine)
Gas bolck, any low profile .750 gas block will do the job.
We cannot source the forward assist, gas blocks, gas tubes or heat shields from Colt Canada. At least, not at this time.
The above will get you up and running. Hopefully at some point, Colt Canada will give us the straight tubes, heat shields and gas blocks to
make it 100%
Cheers
Just for my own clarity: Will the MRRs accept bent gas tubes and the low pro .750 gas blocks? Not that mine is anywhere near worn out, but for future reference.
