cheek piece stock fit

[jbunny]

here are some pic of my bubba cheek pieces. it sure helps your shooting
when u get a good cheek weld. the 2 black ABS sewer pipe cheek piece
on my savage 44 mag and 308 FVSS. the wood stock is my ruger 10-22
target. i also cut an inch of the end of the barrel and tapered it. it only
took 3/4 pound of but it was off the muzle end and it feel like 3 lbs
less. all and all i've had a busy week. now if i just had more money!!!!!
jb

 

[sniper58]

Just so everybody knows, I've been to jbunny's shop and have threatened him that I'm going to pitch my tent in his yard and spend 2 weeks on vacation in his shop!

He is also in the finishing stages of building an electric car.
I wish that I had this man's imagination and talent!

 

[5440fight]

nice job!

 

[maple_leaf_eh]

I made a two-rod cheekrest elevator similar to yours for a target rifle. I found that the rest would collapse unexpectedly. To prevent reoccurences, I nibbled some thin veneer strips to nest between the horizontal surfaces, indexed on the rods. If a firing point is quite sloped or the back sight had to be cranked up higher than zero, I put in more spacers.