Cheek rest/riser questions

Thanks for all the input folks. Ended up with Jahns 3d printed variant as it suits my specs as close as possible. The neoprene sock and foam was my back up plan if I couldn’t find some plastic variant that suited my purpose better.
My main concern with snagging is my pack design, and the way my rifle is intended to slip in/ out in rapid deployment. Hence the less chance to snag on my pack the better ! Will update with photos when the platform is setup
 
Well, here is some updated photos from multiple angles from Jahns 3D printed cheek rest. Fit and finish is great, height is perfect as is for me, experience may vary depending how high youre cheek bones are. 10/10 very happy with his design!
Thanks Jahnj0584 !
IMG_3863.jpg
IMG_3867.jpg
IMG_3866.jpg
IMG_3865.jpg
 

Attachments

  • IMG_3863.jpg
    IMG_3863.jpg
    71.6 KB · Views: 135
  • IMG_3867.jpg
    IMG_3867.jpg
    44.9 KB · Views: 135
  • IMG_3866.jpg
    IMG_3866.jpg
    34.3 KB · Views: 133
  • IMG_3865.jpg
    IMG_3865.jpg
    55.8 KB · Views: 135
Had a cheek riser made for a Rem 700 VS with the HS Precision stock. Fits perfectly, works great and looks great to boot. Very impressed, very highly recommended.
 
Adjustable cheek riser all the way. Drill 2 holes, install, done. It's really the only way you'll get an absolute perfect cheek weld unless you completely luck out a stick on one that matches your scope height.
 
FEDGE2.0 said:
Adjustable cheek riser all the way. Drill 2 holes, install, done. It's really the only way you'll get an absolute perfect cheek weld unless you completely luck out a stick on one that matches your scope height.
Click to expand...

I disagree. I measured everything carefully, made up a template, sent it to Jahnj0584 and am 110% impressed ( and I am not easily impressed). No ugly holes drilled in the stock. The scope was on the gun before measurements were taken.
 
You must log in or register to reply here.
Back
Top Bottom