Choate Tactical Stocks

[Mystic Precision]

Stock will be inletted for factory bottom metal or a blind mag so that you can inlet for the aftermarket bottom metal you want.

If you use CDI, you can start with either as there is quite a bit of inletting required.

Jerry

 

[dthunter]

Mystic:

Can this stock be used by left handed shooters?
Or does the comb adjustment knob not attach to the other side?

Also, can I get this stock inletted for rem 700 Short/long actions as well?

I have a Long action,700,DBM. (3006) Would this be feasible with out a huge amount of modification?

If I had to go to a blind top feed magazine, it wouldnt be a problem though.

 

[juanvaldez]

Stock will be inletted for factory bottom metal or a blind mag so that you can inlet for the aftermarket bottom metal you want.

If you use CDI, you can start with either as there is quite a bit of inletting required.

Jerry

CDI metal for savage is drop in fit on most stocks. Choate leaves a little ridge on AL bedding block that gets in the way, other then that it is the same outline as factory savage metal.

 

[Jamie]

what about there 700 folder?

 

[Mystic Precision]

CDI metal for savage is drop in fit on most stocks. Choate leaves a little ridge on AL bedding block that gets in the way, other then that it is the same outline as factory savage metal.

Certainly wasn't a drop in with the Choate stock we just fixed.

Jerry

 

[Mystic Precision]

Mystic:

Can this stock be used by left handed shooters?
Or does the comb adjustment knob not attach to the other side?

Also, can I get this stock inletted for rem 700 Short/long actions as well?

I have a Long action,700,DBM. (3006) Would this be feasible with out a huge amount of modification?

If I had to go to a blind top feed magazine, it wouldnt be a problem though.

Choate does offer the custom tactical in LH versions. But the LH stocks are usually special ordered and do take some time to get.

All the Rem versions are offered in ADL or BDL. There are no factory det mag models so fitting is required.

I am working on a supply of Choate Folders

Send me a PM or email with your enquiries so I can give you info and book the stocks. Not supposed to talk sales on this forum.

Jerry

 

[juanvaldez]

Certainly wasn't a drop in with the Choate stock we just fixed.

Jerry

Reallly? What did you have to do with it? Cdi bottom metal drops in to savage factory stocks and hs precision. The choates I have seen only required removal of some of the bedding block material. I wonder if cdi changed their bottom metal for savages?

 

[juanvaldez]

All the Rem versions are offered in ADL or BDL. There are no factory det mag models so fitting is required.

Jerry

Unless you use hs precision bottom metal, it will fit into most bdl inlets, never tried on a choate so ymmv