You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
choked barrel for hatsan optoma
- Thread starter robchar
- Start date
Rayleigh_Scattering
Regular
- Location
- Under the arch
My attempts to get any info/support out of the Turks were completely unproductive.
The lesson for me was to buy something with a logistics tail next time.
And if it costs a few hundred more I can at least get a manual, parts, and a bushel of YouTube videos showing “If it does this, adjust/replace this part here.”
The lesson for me was to buy something with a logistics tail next time.
And if it costs a few hundred more I can at least get a manual, parts, and a bushel of YouTube videos showing “If it does this, adjust/replace this part here.”
Beretta687EELL
CGN frequent flyer
- Location
- SW Ontario
Find out who distributes Hatsan in Canada and contact them. I suspect that you will have a similar result as Rayleigh.
Rayleigh_Scattering
Regular
- Location
- Under the arch
I’ll add that parts commonality between the different imports is limited in the ones I’ve handled. You’d think that a 12ga 3” 19” barrel from one semi made at the factory should mount to the receiver of another one made a few years later, but it doesn’t in the ones I tried. The cylindrical receiver interface and piston spacing were a few mm off.
Same for stocks. Frustrating. And the ones that use a ring interface that looks like the Mossberg ring pattern have a ring that isn’t the same diameter as the Mossberg ring.
Still, when they work they work.
Same for stocks. Frustrating. And the ones that use a ring interface that looks like the Mossberg ring pattern have a ring that isn’t the same diameter as the Mossberg ring.
Still, when they work they work.
Last edited:
