CIL Model 402 ejector parts

Kenjames

Kenjames

CGN Regular
Rating - 100%
1   0   0
Location
Northern Ontario
I have a single shot CIL 12 gauge Model 402 from Brazil. The ejector gear has a broken tooth. Western gunworks, Numeric and Brownells does not stock. Any help greatly appreciated. It has served me well for 55 years and I would enjoy using the old girl for a few years yet.
 
I can not say that I have played with that exact issue - but I think those shotguns were also stamped and sold as Remington Model 812 and CBC Model 151 - so you might have some options for identical parts?
 
If you go here: htt ps://www.gunpartscorp.com/gun-manufacturer/remington/shotguns-rem/812 - you will see that Numrich is showing Remington 812 schematic and various parts - it may or may not be what you are looking for?? I have ordered a few times from them - in New York State, I think - I believe sort of flat rate $US 18 to mail stuff to us.
 
Potashminer, You just made an old man very happy. That is the exact part I require. The old girl lives now, thanks to you. Gunnutz is such a great resource. 24 minutes and I got the help I needed. Once again much appreciated.

Ken
 
Ken - it all "goes 'round" - a neighbour stopped by with a decrepit looking .410 shotgun that he inherited from an Uncle - stock at wrist was broken and held together with hockey tape. He wondered if I could "fix" it - was stamped as Remington Model 812. A CGN guy sold me some firing pins and firing pin return coil springs - said they were all the same - CBC 151, Rem 812 and CIL 402 - so, I assumed other parts might swap - that Rem 812 was stamped as "Made-in-Brazil".

You are not exactly "out of the woods" yet - still have to get the parts - and then they have to fit and work!!!
 
You must log in or register to reply here.
Back
Top Bottom