Cooey 39 Top Scope Mounts

8

88 man

Regular
GunNutz
Rating - 100%
406   0   0
Location
Grafton Ont
I've got an old Cooey 39 and looked on the Weaver web site and they only list the side mount and I want to put top mounts on.My 22 isn't tapped at all.Anyone know what # bases could be used ?
Thanks !
 
Local 'smith did a few before closing their doors a couple of years ago. The last couple were a one piece, aluminum base, and he'd cut a notch out of them for easier loading. Pretty certain it was 4 taps right down the middle to retain them.

Although it's a pretty long thread, there are a few scoped Cooeys in the Cooey Makeover thread that might provide inspiration.
 
Still looking for mount # for my old cooey.I looked through the cooey make-over thread but couldn't see any mount #'s.Can anyone let me know what # mount you used and if it was a 1pc or 2 pc mount ?
Thanks !
 
i just finished mounting [drilled and tapped ] my COOEY mod, 60 receiver to install a WEAVER 92A TOP MOUNT BASE [one piece] $15.99 for the base ..installed weaver rings and scope ..did not want a side mount with a small diameter scope ..

i did the same thing for my mod. 39 COOEY ...the hardest part is making sure that the base is dead center ..on the barrel ..


http://i18.servimg.com/u/f18/10/06/04/87/cooey_10.jpg
 
Last edited:
You do know the sheet metal side mts. came in 3/4" ,7/8" + 1" rings? Weaver two piece side mt plate and rings still made in 1" I have one on a model 60 with a 2.5 K Weaver scope.........Harold
 
I know they still make the 1" side mounts but at $50+ for that plus the drill and tap cost just using a top mount is a lot cheaper in the end
Thanks though !
 
You must log in or register to reply here.
Back
Top Bottom