cooey 64 problem

loogie33

loogie33

Regular
EE Expired
Rating - 100%
12   0   0
hi guys.... i have a cooey 64 with a wee bit of a problem..... I took it apart to clean, put it back together and everything works except the trigger assy.... when i #### it the bolt slides back, loads etc but the trigger is solid.... if i loosen the screws that are holding the assy in i hear the bolt slam forward as if i had fired it.... i have tinkered with this for hours and cant figure it out.... i looked at the breakdown on savage but it still doesnt show me what i'm missing..... i'm 100% sure i didnt lose any parts just cant figure out how it fits..... anyone else have this??? any ideas would be greatly appreciated.... thank you...
 
You may have a long screw holding things back ( try a washer)or the sear and disconnector are not fitting into their proper slots. Was it working before you took it apart or is it a new or different part? Did you disassemble the trigger assembly?
 
You are missing one (or both) of the washers for the 2 screws that hold the trigger assembly to the receiver. Without them, the screws are just to long to snug up.
 
hakx said:
You are missing one (or both) of the washers for the 2 screws that hold the trigger assembly to the receiver. Without them, the screws are just to long to snug up.
Click to expand...
He's dead on
 
You must log in or register to reply here.
Back
Top Bottom