Cooey model 60 feeding issue

E

Eugon

New member
Rating - 0%
0   0   0
Hello everyone.

I am new to the hobby and this forum. I bought a Cooey model 60 from a good friend, and it shot great. After a full day of shooting I did a full take down and cleaning, and after reassembling it has a feeding issue. The rounds seem to be getting caught under and to to right of the bolt and are not being picked up. If anyone could tell me what I've done wrong when reassembling it I would really appreciate it. The action cycles well when empty, but it just wont chamber rounds out of the tube magazine.

Thank you, Eugon

**Image and video linking functions will be enabled after you have contributed more to the forum****Image and video linking functions will be enabled after you have contributed more to the forum**
 
There's a knurled nut that holds the stock on.
The stud it threads onto is itself locked in place by a hex nut.
When reassembling, make sure the stud just barely clears the linkage when working the action.
Also, make sure the feed bar is centered under the bolt. It might need a bit of tweaking if it got inadvertently bent.
 
I think I have the hex nut set properly. It barely clears the magazine, and the action seems to work well. I don't know what the feed bar is though. Is that the articulated pole that stick out of the magazine rod?
 
I figured out what it was, and it was the feed bar! Somehow it had become bent to the left and would wedge the round between itself, the wall of the receiver and the extractors on the bolt. Just a little pressure with a screwdriver and it working perfectly! Thank you!
 
You must log in or register to reply here.
Back
Top Bottom