I have to comment on the Crimson Trace laser grips that I installed on my 4.25" shortened Ruger SRH in 454 Casull.
After many full house 240gr to 405gr loads I am amazed at how this unit retains it's point of aim.
I have the laser sighted in dead on @ 25 yards, all I have to do is hold the laser's dot on target and the next thing I know when the gun comes back out of recoil there is a new hole and if I did my part by holding the gun properly the holes after the 3rd shot just formed a clover leaf in the target.
The one and only negative comment that I can make is that the grip @ the top rear hole on the left side where one of the four screws that holds the grip together sticks out way to far.
I had to take my dremel and grind this area down so the grip didn't pound the first joint of my thumb.
Anyway if the Crimson Trace laser grips can hold up to the punishment of the SRH/454 Casull combo it will stand up to anything.
I highly recommend these units...
After many full house 240gr to 405gr loads I am amazed at how this unit retains it's point of aim.
I have the laser sighted in dead on @ 25 yards, all I have to do is hold the laser's dot on target and the next thing I know when the gun comes back out of recoil there is a new hole and if I did my part by holding the gun properly the holes after the 3rd shot just formed a clover leaf in the target.
The one and only negative comment that I can make is that the grip @ the top rear hole on the left side where one of the four screws that holds the grip together sticks out way to far.
I had to take my dremel and grind this area down so the grip didn't pound the first joint of my thumb.
Anyway if the Crimson Trace laser grips can hold up to the punishment of the SRH/454 Casull combo it will stand up to anything.
I highly recommend these units...
