Hey guys, so I had a 12" DD Lite rail installed on my Armalite, along with a low pro gas block. After receiving the rifle bad, I had to readjust the rail due to it being slightly off center from the upper reciever, however, I noticed that the gas block was installed slightly off, about 1-3 degrees to the right 1 o'clock position. I haven't test fired anything yet because I am unsure if this will the safe or not. I am in no way an expert and I don't want to risk damaging my firearm. Is this normal and cause for concern? Or should I atleast test fire it? Thanks guys.
Crooked low pro gas block
- Thread starter TK-Hryciuk
- Start date
Most gas blocks have a .125" (1/8") hole in them, as such they allow for a rather generous amount of error in them to be installed and still function.
I would not be concerned about function or safety, but cosmetically it is annoying.
I would not be concerned about function or safety, but cosmetically it is annoying.
