Crossman Backpacker trigger group info request!!

[Levi Garrett]

I took it apart, and one of the 2 small coil springs, I can't figure where it goes(I know its got something to do with keeping pressure on the cross bolt safety, but position is not clear.
Other spring is part of the stock takedown pin, which I got back as it were, but only problem is that darn cross bolt spring.
On a good note , I sprayed some moly into the pump chamber, its harder to pump now, and hits 25% harder.
I just got this 22 cal pellet gun for packing, and stripped it to access ther barrel for proper cleaning, it was used, looks good now.
Any help would be wonderful on the spring install....
Update, went to Crossman site, may have it, will give it a go, thanks for reading , ....

 

[gandalfe]

Are you talking about, the little tiny spring that sits on top of the ball bearing, to allow the saftety to stay on?A lot of people lose this spring, because it is so small.I use, a small amount of grease, to hold the spring, and ball bearing, in place ,while I screw, the barrel down.I've taken apart, these guns, many times, and can help.

 

[Levi Garrett]

Darn, no wonder it would not sit vert along the edge and do anything, I must have lost the ball bearing, also there is a washer , spring type(ie. does not sit flat, not sure where it goes), I put it on the trigger retaining cross pin, looked like it went there, is it poss that this went at the bottom of the vert spring to keep tension???