Custom barrel identification

B

BrianRiddle

New member
Rating - 100%
30   0   0
Location
Airdrie Alberta
Hello I have two barrels im trying to identify who made. One is a 6 groove 6 flute 0.225” wide flutes 0.760 at the muzzle I could take it out of the stock if diameter at the action would help. The second is a 4 groove 1.060” muzzle. Let me know if there is anything else I could use to try and determine who made them.
 
If there is nothing on the breech end of the barrel then it it pretty much impossible to determine who made them as some custom barrel makers will produce almost any configuration for a customer, so if your selling them it will just have to be as unknown maker.
 
Ditto above.

No hope of figuring anything out by the measurements.

Without the original markings, or in the odd case that a gunsmith actually marked the barrel maker's name or his own, its just a barrel.

Case in point, I have a rifle with a barrel on it, and the best I can reliably and honestly say about it is "I was told it is a Douglas Barrel". No way to prove or disprove that. It shoots OK, but I sure as heck wouldn't tell anyone more than that.
 
You must log in or register to reply here.
Back
Top Bottom