Cx4 Barrel Shroud

[kevin.wall]

I've seen a few Cx4's with some neat looking barrel shrouds, and went to look if I could find one. Looked through the sponsors and couldn't find one, does anyone know where I could find one for 9mm Cx4?

 

[geeg]

I bought the one shown below from the US. Its the 'official' shroud from Beretta. There are different ones out there though.

I'll send you a pm with the name since its not a sponsoring dealer.

 

[wigglenator]

does it fit the modded barrels to make the rifles nonres?

 

[geeg]

I would assume so since it slips over the barrel and is held in place with various screws.

They are advertised for the 9mm, .40 and .45 still.

 

[glock9x19]

does the shroud come out of the frame? or do you have to get the barrel threaded?

 

[Snausages]

does the shroud come out of the frame? or do you have to get the barrel threaded?

They just slide over the Barrel and are held in place by a set screw, At least mine does. I bought if off the Net but can't recall where.

 

[blaxsun]

h ttp://www.nortje.com/Products/Shrouds/SHROUDS.htm

 

[jjohnwm]

does it fit the modded barrels to make the rifles nonres?

My non-restricted barrel is slightly heavier in profile than the OEM barrel, so slip-on shrouds will not fit without modification.

 

[rivetc78]

Got this at home depot...I should have bought the black pipe I think.....

 

[Uberfiend]

Barrel Shroud

I got one like geeg from the US, got it off of www.berettaforum.net. It doesn't count towards making it non-res unless it is welded on, these are made of anodized aluminum so that ain't happening. There were some of the venilated ones on Ebay.

 

[Epoxy7]

I had the non restricted bull barrel put on mine. Same sort of look only it actually does something