CZ 600 Trail Mounting

[tyyota]

I have a CZ 600 Trail on order. I plan to mount a Burris Fullfield 2.5-10x42 with 1" tube.
The 600 Trail has a long Picatinny rail. What are the prevailing mounting solutions for this combo? I want a the scope position as low as possible.
T

 

[True Shadows]

With 42mm probably medium height rings. Maybe even low rings. You'd have to measure to be sure.

 

[Man50n]

1.5in Cantilever is about the only way to make them comfortable.

 

[Can-down]

Here's a good set of 1 inch med rings made in the USA For less then $90.00 shipped to your door.
Too easy....

https://www.amazon.ca/UTG-RWU012515...sprefix=utg+pro+medium+1+rings,aps,531&sr=8-1

 

[Can-down]

1.5in Cantilever is about the only way to make them comfortable.
View attachment 1017996

Or you could extend the stock a bit.....
But seriously, is a cantilevered setup the only thing that works on the Trail? I've seen guys with one piece mounts but the mount was on the receiver and could have been easily mounted with a pair of rings.

Tyyota, your best bet might be to wait till you have the rifle and scope in hand and play around with it and see where you need the scope to sit for the best eye relief. If you do need a cantilevered set up, the aero precisions are a nice option and the 1 inch models are usually a bit cheaper.

 

[Can-down]

That scope looks pretty compact, but it also looks like you will need med rings to stay above the height of the extended rail.