CZ 858 issue

[RMILL]

after cleaning my 858, i was reassembling it, and like an idiot, i put the spring that goes into the lower whole into the wrong whole. therefore, when i reassembled and pulled the bolt back and i bent the spring.
I then foolishly decided to assemble the gun without this bent spring while i source a new one.

SO, this is a 2 part question -
1) where can i get a cz 858 spring kit (if at all possible without buying the parts kit from wolverine)
2) how can i dissassemble the gun without the spring in place - i cannot remove the bolt carrier since i cannot pull the trigger.

any help would be greatly appreciated.
thanks
Ryan

 

[Stevo]

If the striker spring is not installed, try holding the gun vertically with the muzzle down and pull the trigger. You should be able to get the striker off the sear that way. You may need to tap the muzzle on the ground while holding the trigger to the rear.

 

[RMILL]

Huge man! i am at work right now, but i appreciate the help. I will most definetly let you knnow how that works out for me tonight.

cheers

 

[svt1940]

after cleaning my 858, i was reassembling it, and like an idiot, i put the spring that goes into the lower whole into the wrong whole. therefore, when i reassembled and pulled the bolt back and i bent the spring.
I then foolishly decided to assemble the gun without this bent spring while i source a new one.

SO, this is a 2 part question -
1) where can i get a cz 858 spring kit (if at all possible without buying the parts kit from wolverine)
2) how can i dissassemble the gun without the spring in place - i cannot remove the bolt carrier since i cannot pull the trigger.

any help would be greatly appreciated.
thanks
Ryan

For your springs, call Wolverine, i'm sure you can get springs only.
Jocelyn