The factory uses an air tool to tighten the stock bolt, which puts a pile of pressure on the wooden stock. Sometimes the only way to get it off is to do what was mentioned above - cut the stock at the bolt to relieve the pressure.
cz 858 stock question.
- Thread starter rodngun
- Start date
Scott,
That's an Ace AK/AR grip adapter with a Troy grip. I got the adapter from Neit Arms.
Steve
I went to canadian tire and bought a big ass chisel then ground the tip flat untill it fit the screw head perfectly. This gave me a perfectly fitted screw driver that was tough enough to handle what I was about to put it through. I then applied a sizable ratchet and a bar to it. I think I put it on the floor and stood on the butt. Worked fantastic.
Something like this but it was a single chisel when I bought it and longer than what these appear to be.
http://www. canadiantire.ca/AST/browse/6/Tools/HandTools/ChiselsPunchesFiles/PRD~0581608P/Mastercraft%252B6-piece%252BChisel%25252BPunch%252BSet.jsp?locale=en
Good luck.
Something like this but it was a single chisel when I bought it and longer than what these appear to be.
http://www. canadiantire.ca/AST/browse/6/Tools/HandTools/ChiselsPunchesFiles/PRD~0581608P/Mastercraft%252B6-piece%252BChisel%25252BPunch%252BSet.jsp?locale=en
Good luck.
