Hi all,
Got a used P10C from a CGNer, runs perfectly fine except i noticed that the guide rod sticks out in front of the frame. Did a bit of research talking about the hex screw backing out of the guide rod. So i re-tightened it with blue loctite however it still protrudes just a bit (ie. ~1-2mm). I'm sure it doesn't matter but it just bothers me knowing that its not perfectly in place with the frame. Is there any other solution here?
Thanks for the input.
Got a used P10C from a CGNer, runs perfectly fine except i noticed that the guide rod sticks out in front of the frame. Did a bit of research talking about the hex screw backing out of the guide rod. So i re-tightened it with blue loctite however it still protrudes just a bit (ie. ~1-2mm). I'm sure it doesn't matter but it just bothers me knowing that its not perfectly in place with the frame. Is there any other solution here?
Thanks for the input.
