CZ Shadow 2, aftermarket sights.
- Thread starter caruguy
- Start date
I was going to ask the same thing. I find mine to be great!
Loosen the set screws and tap left or right for windage.
I adjusted the windage on my friend’s original Shadow yesterday, and it’s easy with a set of digital calipers. This is what I did:
Put a piece of green painter’s tape, vertically on a target.
Shot a couple 5 round groups from 10 yds
Saw the groups were centered about 1” left
Got baseline measurement of where the RSP was by measuring the distance from the left edge to the middle ‘ridge’ on the slide. 0.172”
Loosen set screw, RSP was snug
Tap over until it measured 0.167”
Tighten set screw
Shot 3 more 5-round groups
One group was a touch to the right, one a touch to the left, and the last had all 5 rounds on that 1” tape.
Done.
Put a piece of green painter’s tape, vertically on a target.
Shot a couple 5 round groups from 10 yds
Saw the groups were centered about 1” left
Got baseline measurement of where the RSP was by measuring the distance from the left edge to the middle ‘ridge’ on the slide. 0.172”
Loosen set screw, RSP was snug
Tap over until it measured 0.167”
Tighten set screw
Shot 3 more 5-round groups
One group was a touch to the right, one a touch to the left, and the last had all 5 rounds on that 1” tape.
Done.
