Hey guys I bought a fixer upper gun 6 months ago and after trying to a sight out of the states I finally found the correct one and got it here...
The gun I am installing it on is a Springfield P9 which is identical to the CZ75 EEA Witness etc...
I am almost postive you just tap it in place I would have done it already because I have done it on other guns that tap in and hold with set screws but this sight is just held in place with good old friction... the reason I am replaceing the sight is the prevous owner screwed up the orginal one it came loose and went back and forth side to side so I want to make sure its installed correctly...
Some slides require you tap it in from a specific side... some tips would be handy before I sit down tonight to install this.
The gun I am installing it on is a Springfield P9 which is identical to the CZ75 EEA Witness etc...
I am almost postive you just tap it in place I would have done it already because I have done it on other guns that tap in and hold with set screws but this sight is just held in place with good old friction... the reason I am replaceing the sight is the prevous owner screwed up the orginal one it came loose and went back and forth side to side so I want to make sure its installed correctly...
Some slides require you tap it in from a specific side... some tips would be handy before I sit down tonight to install this.
