CZ858 Handguard mounted optics return to zero?

harbl_the_cat

harbl_the_cat

BANNED
CGN Ultra frequent flyer
BANNED
Rating - 100%
53   0   0
If I mount an optic (scout scope/reddot/etc.) on a CZ handguard - does it return to zero if you remove and replace the upper handguard (as you would after cleaning)?
 
I got a FabDefense one on mine and I am able to stay within 3MOA out to three hundred yards after I take it off and put it back on. That's all I am asking from this gun and it's doing it fabulously.
 
CobraGT said:
My FAB ones returned pretty close to zero; a bit off, but not much. My NEA is, so far, wobbly... it was a disappointing range day with it today; need to do some tweaking!
Click to expand...

You can use the installed front set screw to tighten the whole thing up. It will take a bit of trial and error. You can also install another set screw in the threaded hole in the rear "ear" to support it on the receiver lip.
 
CobraGT said:
My FAB ones returned pretty close to zero; a bit off, but not much. My NEA is, so far, wobbly... it was a disappointing range day with it today; need to do some tweaking!
Click to expand...

Mine was tighter than a... Well something that was damn tight! I couldnt imagine mine wobbling under any circumstance!
 
Thanks to NEA for promptly contacting me :) Excellent customer service! :D

I suspect that my rear-sight base might be a bit narrower than spec, which has resulted in my 'wobbly' issue; I'm hoping that the 4th gen rail on its way to me will fit better, as it apparently has more options for adjustment than the 3rd gen I currently have. In any case, don't hesitate to buy from NEA, Jeff's great to deal with :cool:
 
You must log in or register to reply here.
Back
Top Bottom