D4350SCC loads

powdergun

powdergun

CGN Ultra frequent flyer
Rating - 100%
248   0   0
Has anyone tried any of the D4350 in 308 and/or 30 06 loads ? Wondering if anyone was able to get some decent accuracy out of the stuff.

My only experience with this type of powder was with some D4895 in a 223. Best I could do was just under 2" at 100 yards. Using IMR 4895 I got .75" and better.
 
powdergun said:
Has anyone tried any of the D4350 in 308 and/or 30 06 loads ? Wondering if anyone was able to get some decent accuracy out of the stuff.

My only experience with this type of powder was with some D4895 in a 223. Best I could do was just under 2" at 100 yards. Using IMR 4895 I got .75" and better.
Click to expand...

Ive shot lots in 6.5 Creed, similar velocities to H4350. Its probably a bit slow for 308. It shoots 2/3 MOA for me, i could probably shrink those groups but its just short range practice ammo and shoots good enough for what i use it for, velocity spreads were not good at all, like 40 ES over 5 shots or something, but again i have not tried to fix the velocity spreads as im only using it at 200 or 300 yards.
 
It will be much too slow for the 308 Win, since the burn rate is more in line with H4831sc or RL19

D4895 shoots awesome in my 223 (Tikka CTR) with 75gr Amax
 
I have used a boat load of the D4895 and D4064 in the 308. Worked so well i never gave the 4350 a try.

The D4350 works great in my 6mm Rem as it normally likes RL19 and 4831. Shot alright in the creed. Just haven't been up to the range in a while.
 
I was wondering as I have a 30 06 and was going to pick up a 308 as well.

Has anyone used it in a 7mm mag ?
 
Use it as you would RL 19.
Works well in my 6.5 REm mag, 7 wsm, 7 Rem mag, 270 Winchester. Too slow to get the 150's moving fast in the 30/06.
 
You must log in or register to reply here.
Back
Top Bottom