DAMAGE INC. Two Tone Colt .45

[Striker]

My cabinet came with a roll of foam tape..and no mention of it in the instructions..."DOH"
I ran a bead of clear silicone around all the seams..well most of them. I have a couple left. That helped a lot.
Aluminum oxide isn't that dusty..until it starts to wear out.
There are a couple of "capped" holes in my cabinet. The one on the back has a "shield" over it inside the cabinet. I think it is there if you want to hook up some kind of dust recovery system (shop vac).
I can take some pics of the cabinet if you want.

 

[Deckard]

I am looking into homemade boxes if a plan could be found.

I don't know if this would work...
http://www.artsights.com/benchtricks/

 

[Freedom Ventures]

Mine consists of the floor model cabinet from Princess Auto. Got it on sale for $188 and change.
A 50lb bag of 120 grit aluminum oxide was $110..

Next time you're looking for media, check out Atlantic Purification systems in Dartmouth. I got a 50 lb glass bead bag for $50 - they have just about every level of media too.

 

[Striker]

Next time you're looking for media, check out Atlantic Purification systems in Dartmouth. I got a 50 lb glass bead bag for $50 - they have just about every level of media too.

Thanks..I'll try them. I got the aluminum oxide from Atlantic Compressed Air. They stock 80 grit and you can buy it off the shelf at Princess Auto for $50 and change.
I'm going to check with KGCoating and see why they recommend 120 grit over 80.

 

[Nats]

I used the K-Phos pre-treatment. AFAIK, this new Gun-Kote has just come out.Not sure if it is being stocked as of yet.

I seethat VBull has some in stock. Might have to give it a try.