Delete
- Thread starter gunsdora
- Start date
handofzeus
CGN Ultra frequent flyer
- Location
- Trout Creekish Ontario.
Try seating them by o.a.l.
(((Echo)))
CGN frequent flyer
- Location
- Old Man Land, AB
If they're all the same caliber, then they'll work in the M1 carbine. You may have to adjust the COL so they'll chamber.
(E)
(E)
- Location
- The Conservative part of Ontario
gunsdora, could you post a pic of the assembled ammo that does not work, alongside ammo tat does?
Just looking at the bullet pics, they should work, unless there is some sort of feeding issue with the steeper ogive, or you are doing something wrong.
Just looking at the bullet pics, they should work, unless there is some sort of feeding issue with the steeper ogive, or you are doing something wrong.
I don't have any I pull them all over 800 rds. My 30 carbine is 1.671 col. The one that is giving me a problem I whent down to 1.602 col still not feeding properly I would have to sink the bullet right to the taper. The taper on that bullet is not right for the M1 carbine. Look at the other pics . Bullet on the right 110 gr. FMJ, In the center 110 gr. HP no problems with them. There is not enough taper on the other bullet on the left . It has to be for another gun ???.
Last edited:
