Did some mods to my Kel Tec sub 2000
- Thread starter pc9
- Start date
No offence, dude, but that optic is hideous on there. The rest looks great.
There must be a smaller riser that will give you enough clearance, or try a different optic. That thing just offends the eye, like a shopping cart rear spoiler on a civic. You asked, I've got to be honest.
There must be a smaller riser that will give you enough clearance, or try a different optic. That thing just offends the eye, like a shopping cart rear spoiler on a civic. You asked, I've got to be honest.
Actualy that sight works well for me.My cheek sits high on the stock so any lower of a sight and i wont be able to see it.Others might be able to get lower on it but not me.
I dont think it looks too bad
Well, if it works well, that's what counts. Better it work and look goofy, than look better and work goofy. Besides, beauty is in the eye of the beholder.
$675 from Lance Shooting Supplies. They are a lot cheaper in the US but compared to the other options here in Canada for a 9mm non-restricted I feel they are the best option.
Looks great! I just installed the same stuff on mine too!
I also was running into the issues with the stock sights getting in the way. I modded my rear sight so it would fold forward and with a small riser, my red dot is just above the front blade so it's not obstructed. I have a quick detach riser so I can install/remove it quickly (holds zero) and still use the "irons" and fold it up.
I used red locktite on all the screws (and even the barrel nut) and after 100 rounds shooting today, it's held up perfect. These are definitely the gen 2 handguards. On the KTOG so many users report the first gen one falling apart and breaking almost instantly because of how it held on to the barrel lock nut/barrel.
This new one uses a pretty heavy clamp that attaches to the barrel nut with some beefy barrel clamps too.
I also was running into the issues with the stock sights getting in the way. I modded my rear sight so it would fold forward and with a small riser, my red dot is just above the front blade so it's not obstructed. I have a quick detach riser so I can install/remove it quickly (holds zero) and still use the "irons" and fold it up.
I used red locktite on all the screws (and even the barrel nut) and after 100 rounds shooting today, it's held up perfect. These are definitely the gen 2 handguards. On the KTOG so many users report the first gen one falling apart and breaking almost instantly because of how it held on to the barrel lock nut/barrel.
This new one uses a pretty heavy clamp that attaches to the barrel nut with some beefy barrel clamps too.
winnipegger
CGN frequent flyer
you know what might look cool on these guns. if you could turn down the OD of the little section of barrel past the front sight then turn some threads onto it. Then find a long flash hider (maybe from a fn fal?) and then bore that out (the flash hider) and thread it internally so you could thread it like right down to the front sight.... or maybe something like that.
