dies needed

[SVI man]

delete

Im looking for 38 Super dies, i have been told that a full length seating or sizing die will help to get rid of the bulge at the bottom of the case. Im running an open gun and im running out of brass. any helpfull info would be great.

Glen

 

[roberti11]

Die

I had the same problem with my .40 and .45 and used a Lee Carbide factory crimp die, the die is full length and gets rid of the bulge during the crimping process.

I have used this to fix loaded ammo that would not chamber, and it worked so well on my first 1000 round run that I got rid of my roll sizing press.

[FONT=Arial, Helvetica, sans-serif]http://www.leeprecision.com/cgi/catalog/parts.cgi?1169260676.5364=90866[/FONT]