Was loading 9mm, small primers with no problem...recently switched over to .45 which requires the large primer delivery system, I ordered directly from Dillon and put it in (changed the delivery tube as well)...problem is that I end up with more than a fair share of flipped over primers, upside down, sideways....anyway, kind of pissing me off. Am i supposed to lubricate the primer delivery system? Anybody else run into this problem?
Dillon SDB primer probs
- Thread starter scottshotz
- Start date
There is a small lever that pushes to primer forward onto the little cup that holds the primer as it is pushed into the primer pocket as the main arm is pulled down.
There is a small adjusting screw under a little metal tab . Where the screws are that hold the primer tube in place, in the middle is the tab.
Adjusting this screw will make sure that the primer goes onto the cup.
Too much or not enough & the primers will get flipped.
There is a small adjusting screw under a little metal tab . Where the screws are that hold the primer tube in place, in the middle is the tab.
Adjusting this screw will make sure that the primer goes onto the cup.
Too much or not enough & the primers will get flipped.
