I tried punching out the little pin on the front that holds the mag latch/spring/ sear in.
Ended up bending one of the ears on the trigger assy(did not get the pin out,or to even visibly move), not much, but could see it with a straight edge.
Mag latch would not move.
Bent it back some, but straight edge says its still tweaked.
Mag latch works fine, but not quite as smooth as before(but acceptable).
Trigger feels allot better than before
I would still like to get it apart to clean up any machining marks/ etc on the sear guides and to be able to take it apart to try Wolff springs.
Any tips so I dont bend the trigger assembly?
I feel the standard "get a bigger hammer" would be a bad choice here.
Ended up bending one of the ears on the trigger assy(did not get the pin out,or to even visibly move), not much, but could see it with a straight edge.
Mag latch would not move.
Bent it back some, but straight edge says its still tweaked.
Mag latch works fine, but not quite as smooth as before(but acceptable).
Trigger feels allot better than before
I would still like to get it apart to clean up any machining marks/ etc on the sear guides and to be able to take it apart to try Wolff springs.
Any tips so I dont bend the trigger assembly?
I feel the standard "get a bigger hammer" would be a bad choice here.
Last edited:
