Dlask Barrel install help
- Thread starter TheWhole9Yards
- Start date
Sakoman .308
CGN Ultra frequent flyer
- Location
- Nova Scotia
Well done sir, enjoy!
Had it out today, runs great! Initall results are promising - here are some 5 shot groups at 50yrds. -5C with a steady head on wind.
Top left: Eley Match Top Right: Federal Gold Medal Match
Bottom left: CCI Minimag 36gr HP Bottom right: CCI Standard Velocity
Top left: Eley Match Top Right: Federal Gold Medal Match
Bottom left: CCI Minimag 36gr HP Bottom right: CCI Standard Velocity
Attachments
I heated the receiver, put some anti-seize on the barrel, and hammered the receiver down onto the barrel using a 2X4 on the back of the receiver to cushion it from the hammer blows. I wanted the fit as tight as possible, and it is. My biggest fear was the barrel not going in indexed correctly, but an indexing alignment line helped prevent it.
Had this issue before (DAR receiver+ Tac Sol bull barrel), fortunately Dlask office is not far from my living place. Dropped in someday, and the stuffs are very friendly and professional, fixed it less than 15 mins in their workshop without any charge. Thumbs up for their service.
Below is the pic of my 10/22 assembled by Dlask back that day
Below is the pic of my 10/22 assembled by Dlask back that day
Last edited:
Had this issue before (DAR receiver+ Tac Sol bull barrel), fortunately Dlask office is not far from my living place. Dropped in someday, and the stuffs are very friendly and professional, fixed it less than 15 mins in their workshop without any charge. Thumbs up for their service.
Below is the pic of my 10/22 assembled by Dlask back that day
Nice looking setup!
