Does anybody have quick load?

R

rm_rang

CGN Regular
Rating - 100%
53   0   2
Location
Napanee, ON
Hey guys

I’m wondering if anybody has the quick load software and could give me a hand?

I am wondering appx how much trail boss powder would I need to get a 140gr projectile to go 1100 FPS out of a 6.5 rem mag with a 18 1/2 inch barrel?

Thanks!
 
Below is a QL run for LYM LRN GC 266469 and IMR Trailboss
It should give you an idea.


Code: 
Cartridge                  : 6.5 mm Rem. Mag.
Bullet                      : .264, 140, LYM LRN GC 266469
Useable Case Capaci : 62.065 grain H2O = 4.030 cm³
Cartridge O.A.L. L6   : 2.806 inch = 71.27 mm
Barrel Length           : 22.0 inch = 558.8 mm
Powder                    : IMR TrailBoss


Predicted data by increasing and decreasing the given charge,
incremented in steps of 1.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !


Step    Fill. Charge   Vel.  Energy   Pmax   Pmuz  Prop.Burnt B_Time
 %       %    Grains   fps   ft.lbs    psi    psi      %        ms


-10.0   63    12.15   1359     574   19606   2435    100.0    2.029
-09.0   64    12.29   1367     581   19889   2460    100.0    2.015
-08.0   64    12.42   1374     587   20173   2486    100.0    2.001
-07.0   65    12.56   1382     594   20458   2511    100.0    1.987
-06.0   66    12.69   1390     600   20744   2537    100.0    1.973
-05.0   67    12.83   1397     607   21032   2562    100.0    1.961
-04.0   67    12.96   1405     614   21320   2588    100.0    1.948
-03.0   68    13.10   1413     620   21610   2613    100.0    1.936
-02.0   69    13.23   1420     627   21901   2638    100.0    1.923
-01.0   69    13.37   1428     634   22193   2664    100.0    1.911
+00.0   70    13.50   1435     640   22486   2689    100.0    1.899
+01.0   71    13.64   1443     647   22780   2714    100.0    1.887
+02.0   71    13.77   1450     654   23076   2739    100.0    1.875
+03.0   72    13.91   1457     660   23372   2764    100.0    1.864
+04.0   73    14.04   1465     667   23670   2790    100.0    1.852
+05.0   74    14.18   1472     673   23969   2815    100.0    1.841


Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba     70    13.50   1438     643   23074   2684    100.0    1.874
Data for burning rate decreased by 10% relative to nominal value:
-Ba     70    13.50   1431     637   21734   2696    100.0    1.931
 
Last edited:
Ariu said:
Below is a QL run for LYM LRN GC 266469 and IMR Trailboss
It should give you an idea.


Code: 
Cartridge                  : 6.5 mm Rem. Mag.
Bullet                      : .264, 140, LYM LRN GC 266469
Useable Case Capaci : 62.065 grain H2O = 4.030 cm³
Cartridge O.A.L. L6   : 2.806 inch = 71.27 mm
Barrel Length           : 22.0 inch = 558.8 mm
Powder                    : IMR TrailBoss


Predicted data by increasing and decreasing the given charge,
incremented in steps of 1.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !


Step    Fill. Charge   Vel.  Energy   Pmax   Pmuz  Prop.Burnt B_Time
 %       %    Grains   fps   ft.lbs    psi    psi      %        ms


-10.0   63    12.15   1359     574   19606   2435    100.0    2.029
-09.0   64    12.29   1367     581   19889   2460    100.0    2.015
-08.0   64    12.42   1374     587   20173   2486    100.0    2.001
-07.0   65    12.56   1382     594   20458   2511    100.0    1.987
-06.0   66    12.69   1390     600   20744   2537    100.0    1.973
-05.0   67    12.83   1397     607   21032   2562    100.0    1.961
-04.0   67    12.96   1405     614   21320   2588    100.0    1.948
-03.0   68    13.10   1413     620   21610   2613    100.0    1.936
-02.0   69    13.23   1420     627   21901   2638    100.0    1.923
-01.0   69    13.37   1428     634   22193   2664    100.0    1.911
+00.0   70    13.50   1435     640   22486   2689    100.0    1.899
+01.0   71    13.64   1443     647   22780   2714    100.0    1.887
+02.0   71    13.77   1450     654   23076   2739    100.0    1.875
+03.0   72    13.91   1457     660   23372   2764    100.0    1.864
+04.0   73    14.04   1465     667   23670   2790    100.0    1.852
+05.0   74    14.18   1472     673   23969   2815    100.0    1.841


Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba     70    13.50   1438     643   23074   2684    100.0    1.874
Data for burning rate decreased by 10% relative to nominal value:
-Ba     70    13.50   1431     637   21734   2696    100.0    1.931
Click to expand...

Why are you inputting a 22" barrel?
 
For anyone that is interested in internal ballistics software I use GRT. Gordon's Reloading Tool. It's free and the german developer is using Patreon to fund it so his plan is that there will always be a freeware version.

Currently his powder models are mostly Euro and South African and Aussie powders. I use a lot of Vihtavouri which is very well modelled. Some of the Hodgdon powders as well as Alliant are starting to be represented.

I just used GRT to model a load for one of my 375's. Because the 300 gr. bullets are pricey I depend on this software to shorten the load development process. Today the load came in at 2426 fps and the GRT model predicted 2431 fps. Not bad. Groups were .77 Moa (3 shot groups so cheating a bit).
 
You must log in or register to reply here.
Back
Top Bottom