Dummy Ammo ( Snap Cap) 357 mag

E

Enthu

New member
Rating - 0%
0   0   0
I am looking for Dry fire snap caps for my Henry Big Boy Carbine 357 Mag.
I read that the aluminum ones like A-Zoom 16119 .357 Magnum Snap Caps can be tough on extracting mechanism so I was considering brass one like B's Dry Fire Snap Caps (B's Dummy's) for .357 Mag but I can't find them easily in Canada.
I can order them.directly from DryFireSnapCaps.com but some reviewers said there might be issue with Custom.
Does any one have experience ordering from them?
What's your opinion on the aluminum Snap Caps .
Any specific suggestions for 357 mag for my Henry big boy will be highly appreciated.

Thanks in advance
 
Make your own inert round with a de-primed case with a dab of glue from a hot glue gun trimmed flush in place of the primer. Seat a bullet and you’re off. I made some inert rounds for a Savage 99 that worked well. I drilled through the case wall to differentiate them from a live round.
CranePete
 
I I have also cut up little bits of hard rubber ( off old tires) but the glue gun is easier.
I just shot a few round of blazer 357 Alu. cases which would be free if shipping was not so stupid in this country now.
About the only time I used snap caps was testing a gun in then shop, and the plastic ones did not take much use till they where craped out.
I had some metal 22RL test ammo, and it worked very well for many years, mainly to check chambers and fire pins. Don't remember where I got them from
 
You must log in or register to reply here.
Back
Top Bottom