Everything ordered

[jon1985]

Everything has been ordered to start reloading for 9mm.

I currently have:
Hornady LnL ap press; cleaned, installed and ready to go, aswell as 10 spare LnL collets
2000 Campro 147g projectiles
Digital calipers
between 3000-5000 dirty brass ready to clean
ABCs of reloading
Lee reloading manual
Speer reloading manual


On the way is the following:

4lbs Hodgdon tite group
5000 CCI primers
Lee 4 die carbide set
Hornady Bullet feeder die with powder through expander (I don't plan to buy a bullet feeder, but I will try to build one)
RCBS bullet puller
primer flip tray
Hornady electronic powder scale
extra Hornady primer tubes
5lbs stainless steel tumbling media
media separator

I am planning to build a tumbler this weekend and just have a few parts left to track down before I assemble.

I think Im set to go once everything arrives over the next week or so.

Very excited.

 

[Grawfr]

Down the slippery slope to the little padded room he goes... Congrats, and welcome to the asylum!

 

[gewehr76]

Well start with prepping the brass, clean and inspect it first. Select the brand of cases you have most and use them. If you have mixed brass you will have variation in the bullet seating depth, primer seating and overall COL issues.

 

[laker415]

Gotta love getting package after package of goodies. Have fun!

 

[silverfoxdj]

Don't forget a case gauge to check your finished product

 

[Magellann]

It sounds like you have most everything you need under control, soon you will be pumping out the rounds.

 

[silverfoxdj]

And patience goes a long way... good luck

 

[trebor2880]

Down the slippery slope to the little padded room he goes... Congrats, and welcome to the asylum!

ditto

 

[jon1985]

I was planning to build a tumbler today. I managed to find everything I need except a chamber to tumble in. I figured finding 6" PVC wouldnt be to hard....Ive been proven wrong.

 

[Magellann]

Check out a plumbing supplier such as Wolsley, they should have it, hopefully you won't have to buy a full length of pipe for your needs.

 

[silverfoxdj]

I was planning to build a tumbler today. I managed to find everything I need except a chamber to tumble in. I figured finding 6" PVC wouldnt be to hard....Ive been proven wrong.

You could try here: h ttp://pvcindustrialproducts.com/pvc-pipe-and-fittings-ottawa/pipe-sizes-ottawa/

 

[Magellann]

Weed sprayer tanks work very well and most of the work is already done for you.

 

[jon1985]

Weed sprayer tanks work very well and most of the work is already done for you.

I discovered that today! Just need to glue some ridges into the tank.

 

[Seagull]

extra Hornady primer tubes

Just buy the FA vibra prime No extra tubes needed. Those pick up tubes will give you carpal tunnel