I'm also very interested in getting a 10/22 and sending the barrel to a smith for cutting&threading a 1/2"x28tpi... however, I would ask the question in two parts:
1. at what minimal length does the standard 10/22 barrel needs to be cut to get enough "meat" for such threading (and for it to look good with an AR15 flash-hider) ?
2. if this length is below 18" (457mm), then how can you justify the rifle to not become prohib according to the criminal code (restricted is not an issue because it's a rimfire) ? as a side question, when swapping a factory barrel with an aftermarket one (below 18"), is that considered as an "alteration" ?
see excerpt of crim.code below... hummm damn grey zones and obscur gun laws....
"prohibited firearm" means
(a) a handgun that
(i) has a barrel equal to or less than 105 mm in length, or
(ii) is designed or adapted to discharge a 25 or 32 calibre cartridge,
but does not include any such handgun that is prescribed, where the handgun is for use in international sporting competitions governed by the rules of the International Shooting Union,
(b) a firearm that is adapted from a rifle or shotgun, whether by sawing, cutting or any other alteration, and that, as so adapted,
(i) is less than 660 mm in length, or
(ii) is 660 mm or greater in length and has a barrel less than 457 mm in length,
(c) an automatic firearm, whether or not it has been altered to discharge only one projectile with one pressure of the trigger, or
(d) any firearm that is prescribed to be a prohibited firearm;
