Fierce Firearm

[double gun]

Why cant they index the flutes to line up with TDC. I have fit muzzle breaks on three and the flutes were off center on all of them. ??? D.H.

Or inlet the metal flush with the stock?

 

[gerard]

Considering that they have a lot of CNC machines indexing a barrel shouldn't be a problem.
I did have ejection issues with my rifle and had to send it back. They replaced the ejector and magazine. But when they returned my rifle to me they just thru the bolt in the case with the rifle. Once it arrived it had quite a few scratches and rub marks on it. I wasn't a very happy camper i tell you.
I then had to send it back again and Fierce had to build me a new rifle.
I'm just hoping that this rifle shoots well.

 

[shotgun64]

Hi guys I just bought a Fierce Edge rifle in 300WSM. I thought the fit and fininsh were very good with an excellent carbon fiber stock. I am in the process of working up a load, but it likes the 165 accubond, with H4350. The only thing I did not like was that it was scratching the brass a little bit when loading from the mag. You should not have to do this when you pay that much for a gun. I cleaned up the ramp and it is almost eliminated now.
The gun shoots very well, and I will test fire it again when I get a chance. I put a Swarovski Z3 4-12X50 on it with Talley low rings. Clears by about an 1/8" from the barrel.

 

[pazzo]

I put a Swarovski Z3 4-12X50 on it with Talley low rings. Clears by about an 1/8" from the barrel.

What base did you use, and is it aluminium or steel?

 

[shotgun64]

I put the light aluminum 1 piece base ring set up.

 

[LongBomber]

To make a long story short, I finally got my edge ti in 26 nosler. The fit and finish is not perfect, but it shoots. I used the powder charge from the test target and ran three different seating depths, starting from .010" off the lands and moving off in 0.020" steps. Here is 0.030" off, 140 gr bergers, 84.9gr us869.

0.050" off