Finally here!

D

Dessert27

New member
Rating - 100%
10   0   0
Location
Québec
Just receive my new 1911, it's a Springfield Armory TRP.

4552084271_f7a7213935.jpg


4552085291_0550ea39d4.jpg


4552726128_5cd1927d53.jpg


4552087557_35c1308469.jpg


I love it, but i have see something and i think it's not normal. It's make some mark on the brass and i don't know what's can cause this? You can see it on next picture just under "AUTO"

4552088569_3a619d8705.jpg


Someone have any idea?


Thank you and sorry for my english!
Pascal
 
Doesn't look like a problem to me! If it functions fine then what's the problem? Might be where the extractor grips the case, or where the ejector hit is on the way out. I've never bothered to look at brass other than to check pressure signs in handloads. I would worry.
 
Hi,

Thank's for reply. I realoading so i want to know if i will have some problem after many reload or if my brass will wear faster than normal?


Thank's again,
Pascal
 
I dunno, that's quite the notch. A few more of those and the rim will likely be swaged to a larger diamter or have enough little swage out tips around the rim to not feed or eject correctly. If there's a part that could be adjusted to eliminate that I think I'd want to do so if it were my pistol.
 
Hi,

Thank you for your reply and comments!

Problem found, it's caused by a step in the breach face.

I will try to contact the store where i buy it to see if he can repair this.


Pascal
 
You must log in or register to reply here.
Back
Top Bottom