finding a coated assembly screw for BAR 22

H

Hydroformed

Regular
Rating - 0%
0   0   0
Location
Ontario
Bought a BAR 22 2nd generation, silver finish on receiver. the only flaw is on the assembly screw, the finish has been cracked off on the edge. from wrong screw driver used when disassembled. slot made to fit a coin, not a screw driver. Any way I need to replace it or refinish it. Cant find one. Any help out there?
 
The screw has to be buggered up pretty bad before you need to replace it. You can most likely refinish the screw with some fine needle files and polish the head to a bright finish to match the receiver. A picture of the screw might be helpful. Numrich might have a replacement if you want to go that way.
 
Numrich has the take down screws but they are blued, the screw head has had some finish on it, nickel or zinc. the receiver is alloy so the screw was coated to match. wish i knew how to use photo bucket, i would have pics.
 
You must log in or register to reply here.
Back
Top Bottom