Running once fired 223 remington cases through a case trimmer mounted on the drill press, cut to length, chamfer and deburr and finally lube and run into a full length sizing die, finally that old lee hand press came to use.
I am using the Forster drill press brass trimmer assembly but I managed to chuck a lee stud and shell holder asssembly into it, the collet on the forster was filling up with to many shavings to get the brass in and locked, the cutter on the drill press is just running the standard 223 pilot on it, seams to work well even after removing the neck, I know because prior to the video and tak down of the set up I trimmed over 1000 223 brass down.
[youtube]KcYNARehSeE[/youtube]
I am using the Forster drill press brass trimmer assembly but I managed to chuck a lee stud and shell holder asssembly into it, the collet on the forster was filling up with to many shavings to get the brass in and locked, the cutter on the drill press is just running the standard 223 pilot on it, seams to work well even after removing the neck, I know because prior to the video and tak down of the set up I trimmed over 1000 223 brass down.
[youtube]KcYNARehSeE[/youtube]
Last edited:
