Gas block alignment tool??? Cycling issues.

That's going to be the plan. Jump from 0.082 to 0.085, then keep increasing by increments of 0.005. There's a few shops in town I will hopefully hear back from tomorrow.

Thanks again for all the help. I will report back when i figure this out.



F22_RaptoR said:
Keep in mind, if you open it up a little too much, you already have that nice adjustable gas block to help you out! But as stated most machine shops will be able to do the work fairly easily! It took me all of 10 minutes to drill mine (most of that was setup), and it was nitrided 4150cmv. 1 drill bit to pierce the nitride, and bore half way, then another to break through very slowly to avoid a burr.

The proper specs for 18" barrels are a little hard to come by, but most seem to run (as previously stated) .104 to .110. Even jumping to .085 may not make a difference, but slowly increasing the size is a very safe bet!
Click to expand...
:cheers:
 
You must log in or register to reply here.
Back
Top Bottom