Geiselle SSP trigger not resetting. Stag 10

[Brianma65]

They told me my SSA-E doing the same was from to light of a trigger press and getting a double trigger pull cause by recoil...so the hammer was getting released and following the bcg home.
Mine only happens when shooting for groups from the bench.

Yes, but it happened when I tryed doing a rapid fire mag dump,as well

 

[Kratos]

From the picture does it not look like the hammer spring is on the wrong side of the hammer? It looks like it is in front of the hammer. Maybe it’s the trigger design.

 

[Brianma65]

From the picture does it not look like the hammer spring is on the wrong side of the hammer? It looks like it is in front of the hammer. Maybe it’s the trigger design.

I installed it the same configuration it came out of the package.
But I’m second guessing now and have left work early, to double check.

And I just ordered a Geiselle National match trigger.

 

[Brianma65]

I installed it the same configuration it came out of the package.
But I’m second guessing now and have left work early, to double check.

And I just ordered a Geiselle National match trigger.

I just rechecked,
It looks the same to me.

 

[Kratos]

I installed it the same configuration it came out of the package.
But I’m second guessing now and have left work early, to double check.

And I just ordered a Geiselle National match trigger.

I obviously need more coffee, if the Spring was out front your hammer wouldn’t move into the upright position. And looking at an SSP the hammer is shaped different, sorry but I was wrong about the spring.

Edit: the side view confirms I was wrong lol.

 

[Brianma65]

It’s all good, I have a new Geiselle national match enroute, should have it tomorrow.
The boys at AE took care of me.

And I now have a SSP for my ATRS Set