Gevarm A6

[Fuzzyfoot]

Hi all, I am stumped on this one, took an old Gevarm A6 apart the other night, thought I was being careful not to lose any parts but as it turns out I may have.

For the life of me I can't figure out how the trigger group assembly mounts to the action when re-assembled! I have the bolt and a small flared round barrel nut and that's it, but what does it go into? Perhaps I dropped a piece? there has to be something else to hold the trigger group to the receiver/action!

Any help/ pics would be appreciated.

 

[577/450]

Google iz yer bud on this one

 

[Fuzzyfoot]

Not much info on google,was hoping someone had one and could possible explain or show pics..

 

[Jgoulin]

Nope. It's pooched for sure now. Send mags to me please.

 

[gunrunner100]

Are there not two roll pins?

 

[Fuzzyfoot]

No, it does not use the 2 pins, 1 bolt with that round nut, some how mounts into the bottom of the receiver..

 

[tiriaq]

The head of the screw engages in a slot in the bottom of the receiver.

 

[jackenfield]

your missing a small allan screw that fit in the trigger housing that tread in the small flared than use a wooden dowell Inside the receiver about 1 inch to hold the nut put the trigger housing firts than you cant put the bolt back
if you need any more help feel free
Jacques

 

[guntech]

Stop using useless photobucket ... all its seem to do is advertise over what you want to actually see...

 

[can14]

All gevarm's should be taken a part with great care,as there aren't any spare parts available
Most people turn their gun into parts when they loose a critical part

 

[marshall]

Stop using useless photobucket ... all its seem to do is advertise over what you want to actually see...

Right on. Hate that.

 

[Eenie]

Hi all, I am stumped on this one, took an old Gevarm A6 apart the other night, thought I was being careful not to lose any parts but as it turns out I may have.

For the life of me I can't figure out how the trigger group assembly mounts to the action when re-assembled! I have the bolt and a small flared round barrel nut and that's it, but what does it go into? Perhaps I dropped a piece? there has to be something else to hold the trigger group to the receiver/action!

Any help/ pics would be appreciated.

PM me your cell # or email and I'll send you the A6 schematic.