GLOCK HELP

[shadowsfall1985]

Hello I have a Gen4 g17. It has been locking the slide back after every shot. I have tried all my mags all factory. Assembled and cleaned put back together correctly. Any suggestions on what the issue is or anyone know a good gunsmith for glocks in canada. Thanks

 

[paratrooper777]

The slide stop lever spring was installed wrong by someone. a simple fix .
spring has to be under or over the locking pin .
cant remember which but if installed wrong
it puts upward presser on slide stop every time slide
opens .shoudl be u tube videos to fix it just need a punch to remove pins
You can probably fix it yourself

 

[Lodi]

Check the spring on the slide stop, it may be pushing in the wrong direction.

 

[gewehr76]

Few things you can try before going to gunsmith.
1 try lubricating the rails on the frame and leave slide lubed wet.
2 try different ammo
3 hold the gun firmly with no movement in the wrist

 

[edgy]

Are you maybe accidentally pushing up on the slide stop with your thumb as you shoot? I know it’s unlikely but I have seen it a couple of times where the strong hand thumb was pushing up with a high grip ( if right handed). Sometimes it’s the simple things
Good luck diagnosing the problem.

 

[Boltgun]

in addition to the comment on the slide stop, check to see if the spring is actually broken on the slide stop. when the slide is off, pull up on the stop, it should spring back down. if the spring is broken, it'll flop.

 

[paratrooper777]

I was a Glock Armourer in my past life
My bet is Slide stop lever spring was installed wrong by
previous owner .
it can happen if not paying attention to spring position
when re assembling Glock Model 17
a simple fix

 

[Tanner51]

As per Paratrooper777, slide stop lever installed wrong.
First to go in is the upper smaller pin in the frame, then insert the slide stop lever with the spring under this upper pin, then line it up with the hole for the lager lower pin to go in fairly easy.
Flick it to see if you have spring tension on the slide stop lever. It should pop back into the little U detect in the frame.
Re install slide, insert empty mag, rack it, should lock open.
If you have snap caps now try racking them through a simulated firing cycle. It should work fine.

 

[paratrooper777]

Correction the "Slide LOCK lever" spring likely installed wrong
take slide off pull up on lever it should always return to down position .
(should have a downward pressure)
if not spring installed wrong

 

[shadowsfall1985]

 

[shadowsfall1985]

So this is how it is installed. It clicks back when I flick it up. The slide release that is.

 

[paratrooper777]

So now a mystery it looks like installed properly?

 

[shadowsfall1985]

So now a mystery it looks like installed properly?

Ya im stumped just thought id check on here before replacing things or takeing to a gunsmith.