Glock sight pusher in Niagara Region?

JonJonM

JonJonM

Regular
Rating - 100%
19   0   0
Location
Ontario
any one have a glock sight installation tool in niagara region? I had someone help with my rear sight but the tool was not tall enough to install a suppressor height sight. Any recommendations? or ways to install without wrecking the new sights?

Thanks

Jon
 
VTUPRS-02-w.jpg


If it's a sight tool like this, I've had several sights that don't fit inside the pusher block like in the photo above. In that case, I secure the slide as far left or right as possible (instead of centered). I then use the outside edge of the pusher, as this gives more clearance.
 
jlomein said:
VTUPRS-02-w.jpg


If it's a sight tool like this, I've had several sights that don't fit inside the pusher block like in the photo above. In that case, I secure the slide as far left or right as possible (instead of centered). I then use the outside edge of the pusher, as this gives more clearance.
Click to expand...

Hey thanks for the tip. The one i tried didn’t have an adjustabe height. I’m looking for someone that has a similar pusher. If i get stuck I suppose ill just order one

Thanks for the tips

Jon
 
Measure the height of the sight from the top of the slide. I'll see if mine will fit it. I have the Glock factory sight tools
 
Did a quick measure on the sight tool. It has .250" of room from the top of the slide. Pretty sure the suppressor sights are taller than that.
 
BooSSted said:
Did a quick measure on the sight tool. It has .250" of room from the top of the slide. Pretty sure the suppressor sights are taller than that.
Click to expand...

Yes unfortunately I think you are correct. The suppressor sights measured for the top of the slide are about .375" tall
 
You must log in or register to reply here.
Back
Top Bottom