Got my knockoff ACOG

[Rock$tar]

Got to say, I am very impressed with the quality. Just need to figure out how to sight it in. I think the scope may be to high to properly sight it in so might need to modify my AK side mount to make it sit lower on the VZ. Will see what happens when I get it back from gun smith see if he can sight it in.

Thoughs, comments, suggestions, hate comments, welcome!

 

[P@rick]

Where abouts did you get it and how much??

 

[loonz84]

Looks great!

 

[Ganderite]

Smith will sight it in?? Don't you just take it to the range, shoot, observe holes, move sight knobs?

Yes, it looks very high. Looks like a AR-15 mount.

 

[Benito]

Jesus H. Christ. The height over bore on that thing is crazy!!
Looks like even getting a chin weld on it might be tough.

 

[snipz]

Does your face touch the stock at all when looking through the scope??....You probably need to replace the factory stock with one that's inline with the bore or change or mod your mount so it's lower...Thats way to high...

 

[Rock$tar]

Where abouts did you get it and how much??

Picked it up on ebay and it was ~80 dollars.

Looks great!

Thanks!

Smith will sight it in?? Don't you just take it to the range, shoot, observe holes, move sight knobs?

Yes, it looks very high. Looks like a AR-15 mount.

Ya, I gave it to gun Smith. I had it out, shot 20 rounds and couldn't even seem to get it on paper. I'm not that much into guns so after 20 rounds I got annoyed with it and said #### it. Ill just get my gun smith to do it.

Jesus H. Christ. The height over bore on that thing is crazy!!
Looks like even getting a chin weld on it might be tough.

I just look through it lol. I'm not really sure were my cheek is on the gun or really care It just look through it, put the cross hairs on a yote and pull the trigger rofl. But your right, it could deff. be lower. Only think I'm worried if I lower it, i might loose my ability to use my iron sights also. It's nice to have the irons for close range shots.

Does your face touch the stock at all when looking through the scope??....You probably need to replace the factory stock with one that's inline with the bore or change or mod your mount so it's lower...Thats way to high...

^^

I'm looking at getting a folding stock for it, so I can carry it easier with me in the woods and it will fit better in my RZR-S. It was never intended to be a tack driver, just something I can pick up quickly, shoot a yote and carry with me in the woods all year long

Thanks for comments!

 

[revilo]

Let us know how it holds up. I've often thought about doing the same experiment with a fake elcan on a C7 clone.