Green scum

old owl

Regular
Rating - 100%
18   0   0
I'm sure this subject has been addressed before but......
What do you use to remove the green scum that sticks to the walls and bottom of the tumbler?
The media I'm using is corn.
Thank you for reading this.
 
i toss in a cut up dryer sheet when i tumble... tens of 1000s of rounds i have never seen any soft of build up on my tumbler.. is your media getting wet or somthing?
 
I know about the dryer sheets, it keeps the dust down.
Last night I tossed out the old stuff and saw the build-up, I tried a plastic scraper with very little success, then I tried some acetone to see if I could liquify the stuff but I got very little to stick to the rag, using anything else than a plastic scraper will scratch the plastic pad and only create more adhering surfaces.

What else can I try?
 
I know about the dryer sheets, it keeps the dust down.
Last night I tossed out the old stuff and saw the build-up, I tried a plastic scraper with very little success, then I tried some acetone to see if I could liquify the stuff but I got very little to stick to the rag, using anything else than a plastic scraper will scratch the plastic pad and only create more adhering surfaces.

What else can I try?

I would give some spray nine and a tooth brush a try, and expect to be at it for a few hours, so you might want a case of beer too.

Edit: On our tumbler, we just leave the scum on the wall, it isn't really bothering anyone.
 
I'm sure this subject has been addressed before but......
What do you use to remove the green scum that sticks to the walls and bottom of the tumbler?
The media I'm using is corn.
Thank you for reading this.

Are you using tumbler to remove sizing lube ?

Hot water and some soap should remove it and a wipe down with a paper towel

a cut up used dryer sheet works good to keep the dust down
 
When I get this build-up on the sides of the tumbler, I consider it time to change to a new batch of media. I've found that if I leave the scum and old media in place, the brass will pick up bits of gummy residue (old accumulated bullet lube?) that has to be rubbed off manually with a cloth. The scum on the sides of the vibratory cleaner removes easily with mineral spirits (Varsol).
 
Back
Top Bottom