Grizz mag fix with pics

Liquid_Snake

Liquid_Snake

CGN frequent flyer
Rating - 99.3%
150   1   0
Location
Alberta
So I got extra griz mags took it out today and had the extra mags not fire when the mag was installed . Took the mag out she goes bang... Got home and seen that the mag was makeing this stick


After looking it over before I got out the file to file the magazine I looked down the mag well one last time and seen this thing was bent no Idea what its called I think its a decocker... Any ways it was bent like a bow inside the mag well I took the trigger out and smacked it on the vice with a brass hammer to make it stright now it is flawless the arrow shows it bent stright in the channel where it belongs

 
Last edited:
I had the exact same problem. Read through here for a bit of info.
http://www.canadiangunnutz.com/forum/showthread.php?t=542552

The slide lock lever rubs on the non factory magazines.

Comparing to my fathers, I ended up hammering the little dimple on the end of the lever(on the inside) so that it was about .065" thick (was about .075). You will have to check with a caliper if your is big like mine was or not.

From there, I had to bend the end of the slide lock lever towards the side opposite of the side the lever is mounted to (so the the lever is away from the lever is away from the side of the receiver).
But only the last half of the lever, so from about where the up/down angled changes.

It may be pretty difficult for you being that you dont have a working one to compare yours to.
So if you cant gets your to work, getting a replacement trigger assembly would be the next step i guess. On mine it was only the trigger assembly that was the problem (actually just the slide lock lever, but it does not appear to be replaceable very easily, looks like the pin is riveted in).

EDIT looks like you got it fixed before is finished posting lol
 
I looked into the receiver the lever was bent into the mag well so I just pulled out the trigger smacked it on the vice with a hammer and now its sits inside the channel it was ment for ....she is good to go works 100% now

Thanx for the speedy reply :)
 
You must log in or register to reply here.
Back
Top Bottom