Grizzly Clip Mag: A question and a suggestion.

[PepeLapiu]

This is my fix:

Care to explain what you did?
I can't really tell from the picture.
But than and again, I get by on my looks alone and not much brains.

 

[CanAm]

the newer factory mags are plastic. the aftermarket mags are steel.

 

[skoal]

Care to explain what you did?
I can't really tell from the picture.
But than and again, I get by on my looks alone and not much brains.

Small upward dent on the front of the follower its a common fix and forcing the shell to feed more front up, ive done it to mine as well.

 

[Juster]

Care to explain what you did?
I can't really tell from the picture.
But than and again, I get by on my looks alone and not much brains.

It is all in the previously linked thread:
http://www.canadiangunnutz.com/forum/showthread.php/1225743-DA-Grizzly-quot-must-do-quot/page3

The follower goes nose down with 5 rounds, the little bolt resists that. I did the dent thing too.

It is a great gun, the folding stock is only $20. The "aftermarket" mags do need fixing.
I must insert and reinsert a mag 50 times, I bet that would smooth the mag changes up.
Edit: there is unnecessary rearward travel on the mag release lever, I reduced the travel by about half, and that helps.