Handgun Lock Box

N

nw mb

CGN frequent flyer
Rating - 100%
41   0   0
...standard 50 cal ammo box...


...using the handle as a guide drill a centred hole in the box itself...


...using a tap wrench enlarge the original, drilled holes large enough to accommodate the lock...


...drill the inner trigger lock so that it will secure against the front plate with bolts...


...drill the front plate to match the holes in the inner part of the lock...
 
Last edited:
...interior view of the lock secured using cap bolts...


...exterior view of the inner lock bolted in place...


...exterior part of the lock fastened into place by sliding it into the inner portion of the lock through the drilled holes...and the handle of the ammo box is secured!
 
Last edited:
I did the same using a bolt with a jam nut on the outside underneath the latch, it takes up a bit less space in the interior, and takes about 5 minutes
006-2.jpg
 
...i'll cut some foam to accommodate a 1911 laid in on it's bbl and who knows what else?

...just signed up for my rpal on december 3...can't wait...6 hour drive down to take it but it'll be worth it!

...was just in the states for a week and drooled over the colt 1911's in the cases there

...trying to prepare the baby's new room!!! ;)
 
You must log in or register to reply here.
Back
Top Bottom