hatsan barrel with chokes

As far as I know none exist, and I was told you can't switch out barrels from other Hatsan models. Might be SOL unless you take it to a gunsmith or create your own choke.
 
There are no barrels to fit the MPA with chokes. I verified this with Hatsan. The gas port location won't work with any of there other barrels. I believe it has something to do with the mag tube. Only two options exist right now. Get the barrel tapped for chokes (remchokes will work) or build a barrel extension like I did that is tapped for chokes.
 
You'd have to verify your thread size. I had heard of some MPA's with an M22x.75 thread and that matches the Saiga, however, most seem to have an M21.5x.75 like mine does. Measure twice before you buy.
 
weasel1 said:
You'd have to verify your thread size. I had heard of some MPA's with an M22x.75 thread and that matches the Saiga, however, most seem to have an M21.5x.75 like mine does. Measure twice before you buy.
Click to expand...

interesting. need to check as i was after a sega choke setup myself for my Hatsan MP with 20" barrel.

note someone recently built there own choke system for a hatsan. It adds a lot more to the front then i would want but so far it soudns like it works. just do search for hatsan over past 2 or 3 months on here and it should show up
 
That would be me! Works quite well, but a bit front heavy after shooting a bunch of clays. One of these days I'll add a few oz of weight to the rear.
 
I looked for a set of external chokes for my Valtro forever. My father-in-law found some at a local gun show, and when I googled the part numbers I found these:

http://www.brignoliarmi.com/11478/h...esterni---benelli---franchi---yildiz---hatsan

Supposedly they fit the external threads on the Turkish shotguns as well... All I know is they work great on my Valtro! Note mine are the shorter ones... The photo is of the 120mm versions they also sell.
 
robchar said:
Anyone know of a source for a replacement barrel for a Hatsan MPA that would have screwin chokes.
Thanks for looking
Rob
Click to expand...

I am in the same boat have been looking for a while ,had e-mail`d kings armory about a choke adapter that would use your external existing thread on the mpa`s barrel they said they was working on a design but that was a year ago . have tried e-mailing again but can`t seem to get any reply ,there should be a good strong market for these type of adapters theres a lot of mpa`s and mp`s out there maybe try to e-mail kings see if you can get anywhere good luck
 
You must log in or register to reply here.
Back
Top Bottom