yes they will have the grooves on them, that is the last op on the lathe and depending on how deep the threads are on that model of tube as to how deep we cut the threads.Looks good, will the final have grooves on the thread nut or remain smooth?.. Also have you worked one up for the Hatsan pump?
yes it is, someone one here is working on a new comp for that hatsan, I talked with them but been so busy I forget who it was
here is the prototype of the hatsan mpa long thread mag tube.
these are being tested at the range tomorrow
The credit card is cleared, ready, and waiting for this Hatsan "thread gap version" extension.
I see it now
yes everyone's guns have been mailed back to them with the new mag tubes and extra goodies.
